All About New Technologies in The Molding Industry

The “normal” molding

Some injection and molding operations use cold water to accelerate press cycle times. In the spring, summer and fall, the the point of the air is high stampaggio materie plastiche legnano enough to cause condensation on chilled molds.

A normal way of dealing with this problem is to raise the coolant temperature so that the

mold is not too cool to condense moisture. When cooling rates are changed to meet weather conditions, resin precessing parameters change as well, which can affect part strength. Also, it becomes difficult to take advantage of short-notice, high-demand for profitable products.

An alternate strategy is to keep the cooling temperatures high, accepting the lower production rates, but compensate by purchasing additional machinery. Then there will be production stampaggio materie plastiche busto arsizio capacity to meet peak market demands. But this leaves valuable capital equipment idle during that part of the year when market demand may be very low.

The way you can avoid the problem...

An energy efficient, dry desiccant dehumidifier absorbs and removes the moisture from the air. Since the air is dry, moisture cannot condense on the cooled mold surface.

There are two basic ways to surround the mold with dry air. When there are a large number of machines located in the same space, the most economical solution is to dehumidify the

entire room.In that case, the desiccant dehumidifier can be added lavorazione materie plastiche Piemonte to an existing air conditioning system. If the machines are separated into several rooms, or if there are only a few machines to protect, a separate dehumidification system can be attached to the machine itself.

The deep-drying capacity of the desiccant dehumidification process allows you to operate the mold coolant system at any temperature you choose. Now you can adapt your process to the requirements of the resin and the needs of the part, rather than having to compromise product integrity because of the weather.

Our value added is, however, the full and dedicated service to all our customers that makes our competitive and ever-expanding reality.

Radice Stampi & Co thanks to his many years of experience in mold making and molding of plastics, is able to meet different market sectors.